This model is currently unavailable.

The Hillquist RF 14-16 Slab Saw
is used for the cutting of medium size rock samples.
Hillquist has for over 50 years had the commitment to
build the finest rock cutting and grinding equipment. 
Fiberglass cabinets, fully automatic feed, Hillquist
diamond blades, full view lid, recirculating
coolant system are some of the reasons why
we're accomplishing that goal.

 
  • CARRIAGE - machine cast iron - adjustable wear surfaces - bronze rail brushing
  • RAILS - 3/4" ground and polished steel shafts
  • CROSS FEED - 3/8" cross feed rails - 2 1/2" cross feed travel - thickness gauge for repeated cuts
  • VICE - 7 1/2" jaw opening x 6" cutting height - nylon jaw faces
  • AUTOMATIC FEED - lead screw drive with split nut engagement - automatically adjusts to the hardness and size of rock
  • ARBOR -3/4" ground and polished steel shaft - two heavy duty factory lubricated and sealed bearings - fiberglass bearing guard
  • BLADE - 16" X .050" HNR-30 Hillquist diamond blade - high concentration diamond
  • MOTOR - 1/2 HP capacitor start -1725 RPM 
  • CABINET & BASE - one piece molded fiberglass
  • LID - full view - vacuum formed clear plastic
  • COOLANT SYSTEM - two compartment settling tank - submersible pump - pumps clean coolant to both sides of the blade
  • DIMENSIONS (with base)- 34" long x 24" wide x 22" high
  • WEIGHT - 100 lbs.

 

Home | Thin Section | Thin Grinder |
Slab Saw RF 14-16 | Slab Saw RF 20-24 | Trim Saw | Supplies

  

 

 

The automatic feed constantly adjusts for varying cutting conditions